Fixed the issue where an inside single groove was starting and ending at the center line instead of honoring the retract and clearance cylinders #10068.Added a new option "Selected Position(s)" for single groove operation radii parameters to allow the user to either cut to the X position of the selected position or the inner radius for outside grooving and outer radius for inside grooving.Fixed issue where for single groove and part toolpaths, if the final peck ended exactly at the total depth of cut, an additional superfluous peck was created.Fixed an issue with turning Profile operations where if the "Use Fixed Lead Direction" parameter was turned off, the leads created were not at an angle with respect to the direction of the toolpath #10284.Fixed a particular case of single groove where the ID groove was starting and ending at the Z axis instead of the clearance plane #10422.Fixed a bug with a particular single groove case where an ID groove was not cutting upto the outer radius #10423.Fixed the issue where an inside threading operation in turning was allowed to end at the final toolpath Z position (unsafe) instead of at the safe Z position #10386.Fixed an issue where a Turning Part operation was not generating the correct toolpath when edge break was turned on and a round grooving tool was used #10672.Fixed an issue where expressions did not persist in the Chuck Offset field in a turning / mill turn setup dialog #10694.Fixed potentially wrong initial tool axis for multi-axis toolpath for stock simulation.Updated simulation to avoid some annoying false reports of collisions for multi-axis toolpath. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |